Construction ID - EPS-BJ1U
Solid / engineered timber floors
Direct, fixed installation
System IDEAL EPS 240 kPa
UDL
3.0 kN/m²
Timber floors
Construction height
JUPITER IDEAL EPS
Supporting ply
Supporting batten
Joist
18mm
30mm
0mm
Technical Data
Construction suitable for floors between rooms of equal temperature
Construction height
Mass
Thermal resistance, R-value
mm
kg/m²
m²K/W
0
2
0.86
System sits between joists avoiding height
Mass excluding floor finish
Part L compliant for floors above heated rooms
.zip includes:
NBS Spec
.DWG
Uniform Distributed Load (UDL)
Point load (≥ 20cm²)
Impact sound reduction
Area of application
Floors with rooms of equal
temperature above & below
Rmin=0,75 m²K/W
Additional information
kN/m²
3.0
kN
3.0
dB
-
This construction is valid for floor constructions located between rooms heated to equal or similar temperature. No further insulation is required to meet Part L requirements.
For ground floor installation see construction EPS-BJ1G.
When installing timber floors without tongue and groove edges it is advised to install building paper or similar under timber floor as possible shrinkage of timber will expose aluminium diffuser plates beneath.
Glue and screw supporting ply to battens.
Aluminium diffuser plates should be flush with top of joists.
